0xb000 is the address normally used with QEMU.
0x400 also appears to conflict with some debug I/O ports
used by QEMU.
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: Jordan Justen <jordan.l.justen@intel.com>
Reviewed-by: Erik Bjorge <erik.c.bjorge@intel.com>
Tested-by: Laszlo Ersek <lersek@redhat.com>
Reviewed-by: Laszlo Ersek <lersek@redhat.com>
Tested-by: Bei Guan <gbtju85@gmail.com>
Reviewed-by: Bei Guan <gbtju85@gmail.com>
git-svn-id: https://edk2.svn.sourceforge.net/svnroot/edk2/trunk/edk2@13279 6f19259b-4bc3-4df7-8a09-765794883524
OVMF does not support SMM. Previously the port value
was set to 0. This should be enough to disable the
SMM ACPI Enable/Disable code paths, but to be
consistent we'll set these fields to 0 as well.
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: Jordan Justen <jordan.l.justen@intel.com>
Reviewed-by: Erik Bjorge <erik.c.bjorge@intel.com>
Tested-by: Laszlo Ersek <lersek@redhat.com>
Reviewed-by: Laszlo Ersek <lersek@redhat.com>
Tested-by: Bei Guan <gbtju85@gmail.com>
Reviewed-by: Bei Guan <gbtju85@gmail.com>
git-svn-id: https://edk2.svn.sourceforge.net/svnroot/edk2/trunk/edk2@13277 6f19259b-4bc3-4df7-8a09-765794883524
QEMU hard codes the GPE0 registers at 0xafe0.
Previously the code assumed that the GPE0 block
would move when the PM Base Address of the PIIX4
PCI device was programmed. It appears QEMU does not
emulate this behaviour of the PIIX4 PCI device.
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: Jordan Justen <jordan.l.justen@intel.com>
Reviewed-by: Erik Bjorge <erik.c.bjorge@intel.com>
Tested-by: Laszlo Ersek <lersek@redhat.com>
Reviewed-by: Laszlo Ersek <lersek@redhat.com>
Tested-by: Bei Guan <gbtju85@gmail.com>
Reviewed-by: Bei Guan <gbtju85@gmail.com>
git-svn-id: https://edk2.svn.sourceforge.net/svnroot/edk2/trunk/edk2@13276 6f19259b-4bc3-4df7-8a09-765794883524
jljusten
hhtian
klu2
lgao4
vanjeff