This fixes BULK data loss when transfer is detected as timeout but
finished just before stopping endpoint.
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: Ruiyu Ni <ruiyu.ni@intel.com>
Reviewed-by: Hao Wu <hao.a.wu@intel.com>
Cc: Star Zeng <star.zeng@intel.com>
Cc: Feng Tian <feng.tian@intel.com>
We send ADDRESS DEVICE CMD in XhcInitializeDeviceSlot(), which will
cause XHC issue a USB SET_ADDRESS request to the USB Device.
According to USB spec, there should have a 10ms delay before this
operation after resetting a given port.
But in original code, there is a possible path which may have no such
10ms delay:
UsbHubResetPort()->UsbHubSetPortFeature()->Stall(20)->UsbHubGetPortSt
atus()->XhcPollPortStatusChange()->(if RESET_C bit is set)->
XhcInitializeDeviceSlot()->(if RESET_C bit is set)->Stall(10)
So this patch is used to fix above issue.
Cc: Star Zeng <star.zeng@intel.com>
Cc: Baraneedharan Anbazhagan <anbazhagan@hp.com>
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: Feng Tian <feng.tian@intel.com>
Tested-by: Baraneedharan Anbazhagan <anbazhagan@hp.com>
Reviewed-by: Star Zeng <star.zeng@intel.com>
In the original code, there exists some mismatches between the real
waiting time and the corresponding timeout comments. For example, the
XHC_GENERIC_TIMEOUT comment says it's 10ms timeout value, but the real
code in fact waits 10s.
So the code is refined to be consistent in code logic and comments.
Note XHC_POLL_DELAY macro also be removed and the polling interval in
XhcWaitOpRegBit() is changed from 1ms to 1us to keep same code style
with other code. It has no real functionality impact.
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: Feng Tian <feng.tian@intel.com>
Reviewed-by: Star Zeng <star.zeng@intel.com>
git-svn-id: https://svn.code.sf.net/p/edk2/code/trunk/edk2@18235 6f19259b-4bc3-4df7-8a09-765794883524
1) XHCI host controller hw always provides more than 5 interrupters.
Now using interrupter 0 to accommodate all received events.
2) XHCI host controller hw always provides 32bytes context size.
Now it dynamically detect context size and construct it.
also solved several issues:
1) Divides 64byte width register access to two 32bit registers access because some XHCI chipsets cannot support a single 64bit access.
2) Remove halt host controller statement in UsbBusDriverBindingStop(). It has been done by host controller’s DriverBindingStop(). And XhciDriverBindingStop() need XHCI host controller is in running state because it need execute DISABLE_SLOT cmd to release h/w resource.
signed-off-by: erictian
Reviewed-by: li-elvin
git-svn-id: https://edk2.svn.sourceforge.net/svnroot/edk2/trunk/edk2@12785 6f19259b-4bc3-4df7-8a09-765794883524
Ruiyu Ni
Feng Tian
Gary Lin
Ard Biesheuvel
Star Zeng
Elvin Li
li-elvin
erictian